Graham Posted October 17, 2012 Share Posted October 17, 2012 I would like to know peoples opinion on the following. As some will know the recent deactivated Webley Mk6 has a small tube welded inside the cylinder - I was wondering about gluing the tips of bullets into the appropriate places and also gluing the detonator ends into the other part of the cylinder (having removed the extractor spring) all to look as if the revolver was loaded. Would this invalidate the deactivation certificate? Obviously I do not intend to wander around the streets with the weapon. Any comments? Quote Link to comment Share on other sites More sharing options...
Tony B Posted October 17, 2012 Share Posted October 17, 2012 Normally the cylinder chambers have to be bored out. I do have a Smith & Wesson 200 that has been deaced and the chamber has solid ends so look like bullets. I also cut down some non primered .38 cases to fill the other end. Quote Link to comment Share on other sites More sharing options...
Chris Hall Posted October 17, 2012 Share Posted October 17, 2012 Normally the cylinder chambers have to be bored out. I do have a Smith & Wesson 200 that has been deaced and the chamber has solid ends so look like bullets. I also cut down some non primered .38 cases to fill the other end. That would be my advice, I have a few Enfield revolvers done like this. The dummy bullets are welded in from the hidden end prior to the ring being welded into the cylinder. I then added some fired .38 short blanks which fit on top of the ring. Quote Link to comment Share on other sites More sharing options...
Enfield1940 Posted October 18, 2012 Share Posted October 18, 2012 My understanding is that there shouldn't be a problem with the deactivation status as long as only the inert bullets are modified, not the gun. I would personally secure them with something like Blu-Tack rather than glue so they are easily removable should someone official wish to inspect it. Quote Link to comment Share on other sites More sharing options...
Tony B Posted October 18, 2012 Share Posted October 18, 2012 I just cut the end of each case, and individually fitted to the chambers which varied due to the maching. Drawback is: It's a bu**er if you open a bit quick and they eject. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.