paulbrook Posted November 26, 2014 Share Posted November 26, 2014 I happen to think this is a great idea. A chap I know converted a B60 engine Dennis fire engine and not only does it make the thing relatively economical cost-wise but it runs an absolute treat. I would commend it to anyone - and there are plenty of folk who know what they are doing to fit the gear (not me by the way) Quote Link to comment Share on other sites More sharing options...
attleej Posted November 26, 2014 Share Posted November 26, 2014 Dear All, Having driven many miles in a Bedford RL I can assure you that a heater is not necessary. The engine will keep you as warm as toast! John Quote Link to comment Share on other sites More sharing options...
winchman Posted November 26, 2014 Author Share Posted November 26, 2014 Dear All, Having driven many miles in a Bedford RL I can assure you that a heater is not necessary. The engine will keep you as warm as toast! John Thanks John Quote Link to comment Share on other sites More sharing options...
winchman Posted November 26, 2014 Author Share Posted November 26, 2014 I happen to think this is a great idea. A chap I know converted a B60 engine Dennis fire engine and not only does it make the thing relatively economical cost-wise but it runs an absolute treat. I would commend it to anyone - and there are plenty of folk who know what they are doing to fit the gear (not me by the way) Thanks for your support. The plan is (assuming the RL deal goes through?) Take it to the LPG place buy the bits and he will tell me how to fit what where etc. Once its done he will set it up and issue the cert, to be honest he was very helpful. This is the difference between owning and not owning it as its no use having something I cant affrd to drive Quote Link to comment Share on other sites More sharing options...
Sean N Posted November 26, 2014 Share Posted November 26, 2014 Dear All, Having driven many miles in a Bedford RL I can assure you that a heater is not necessary. The engine will keep you as warm as toast! John What John said. The only time I've been cold is towing one with no engine in snow. Quote Link to comment Share on other sites More sharing options...
HotBed Posted November 26, 2014 Share Posted November 26, 2014 Don`t forget to get the valve seats done, I have a six pot Land Rover and have just fitted an electronic distributer from Power Spark, it was £100 including coil and leads and it goes very very well, they do do a change over box that alters the timing for petrol and gas, it runs a little retarded on petrol, but at £180 extra I did not buy it, as I start on petrol and as soon as I can I change over to gas. :-) Quote Link to comment Share on other sites More sharing options...
winchman Posted November 26, 2014 Author Share Posted November 26, 2014 I thought you added some lube type dipenser to cope with this? But for the miles we will be doing would it matter? I have just spoken to a good friend from the off roading days and he has donated a 90Litre Gas tank with brackets and is going to empty the shed at the weekend to see what else he has. Just need a vehicle now! Quote Link to comment Share on other sites More sharing options...
winchman Posted November 26, 2014 Author Share Posted November 26, 2014 What John said. The only time I've been cold is towing one with no engine in snow. Thanks I will have to see how it is then once I get it well if it all goes to plan. Quote Link to comment Share on other sites More sharing options...
paulbrook Posted November 26, 2014 Share Posted November 26, 2014 If you want the contact details for my converted Fire Engine fella drop me a line. Quote Link to comment Share on other sites More sharing options...
winchman Posted November 27, 2014 Author Share Posted November 27, 2014 If you want the contact details for my converted Fire Engine fella drop me a line. Thanks PM on its way Quote Link to comment Share on other sites More sharing options...
Sean N Posted November 27, 2014 Share Posted November 27, 2014 Someone I know recently had an LPG conversion done on an S-type coach and is very pleased with it. I don't think there were any issues with the valves. In general, I think there are three things to consider with an LPG conversion - first, the practicalities of the conversion - how will it fit, do you have to have it done professionally, certification, insurance and so on. Second, the type of conversion, particularly single point or multi point injection and the like. Third, conversion costs - a lot of people do diesel or LPG conversions on vehicles almost as a kneejerk reaction to the cost and poor economy of a petrol engine and then spend more converting the vehicle than they ever would have spent on petrol in its lifetime. If as you say you can get it done 'on the cheap' you have a good solution to that! Quote Link to comment Share on other sites More sharing options...
winchman Posted November 27, 2014 Author Share Posted November 27, 2014 Someone I know recently had an LPG conversion done on an S-type coach and is very pleased with it. I don't think there were any issues with the valves. In general, I think there are three things to consider with an LPG conversion - first, the practicalities of the conversion - how will it fit, do you have to have it done professionally, certification, insurance and so on. Second, the type of conversion, particularly single point or multi point injection and the like. Third, conversion costs - a lot of people do diesel or LPG conversions on vehicles almost as a kneejerk reaction to the cost and poor economy of a petrol engine and then spend more converting the vehicle than they ever would have spent on petrol in its lifetime. If as you say you can get it done 'on the cheap' you have a good solution to that! Sean I agree here is my considerations. Cost well thanks to a good friend of mine I have the tank and possibly a few bits and bobs so we are on target to come in at £100. I believe nothing can stop any one fitting one providing once completed it is certified and added to the LPG register. We have a man who has come highly recommended who is familiar with tight wads doing there own work who providing its all done to the correct standard will test and do the paper work. My big consideration is how it will look, so I Have thought of hiding the tank in a belly box, fuel tank etc, I can put the controls out of sight so at a casual glance it should look ok. Quote Link to comment Share on other sites More sharing options...
Sean N Posted November 27, 2014 Share Posted November 27, 2014 Could the tank go up between the chassis rails somewhere? Painted black wouldn't be obvious and might just look like a rather oversize air tank. Keep it well away from propshafts, suspension components etc. - there's a LOT of articulation on an RL! Quote Link to comment Share on other sites More sharing options...
winchman Posted November 27, 2014 Author Share Posted November 27, 2014 Could the tank go up between the chassis rails somewhere? Painted black wouldn't be obvious and might just look like a rather oversize air tank. Keep it well away from propshafts, suspension components etc. - there's a LOT of articulation on an RL! I will have a look when and if I get it. I now cant get hold of the vendor? He was moving house so its possibly he is far too busy, so I may be further away than I thought from my first MV Quote Link to comment Share on other sites More sharing options...
tankdriver Posted November 27, 2014 Share Posted November 27, 2014 I work on LP forklifts for a living, and we tried synthetic oil in our rental fleet to try to cut down on wear and how often we changed the oil. We ran into problems with sludge build up, that did not happen with conventional oils. So be careful if you use synthetic oil. Make sure it is a low ash oil, high ash with NG or Propane is not good, over the long run you will end up with deposit buildups. I did some checking and found that the ash content of synthetic oils varies with the different products just like it does for regular motor oils. Basically it is the proprieties of the oil, loads of info out there on the net but just did a quick search found this one; »www.viragotech.com/fixit/AllAboutOil.html Here is the bottom line as per the above link A high ash content will tend to form more sludge and deposits in the engine. Low ash content also seems to promote long valve life. Look for oils with a low ash content. Quote Link to comment Share on other sites More sharing options...
winchman Posted November 27, 2014 Author Share Posted November 27, 2014 Thanks' for the tip. Its all new to me so any advice is good Quote Link to comment Share on other sites More sharing options...
winchman Posted November 28, 2014 Author Share Posted November 28, 2014 A little update We have a local LPG fitter who has helped me out in the past, I don't like to mither him but I called today. The number one thing is it has to go on the register and have a cert issued cost about £130. The rest he tells me is easy. The bit that goes on the carb is critical as it must be the correct size, so he recommends we buy a new one, the rest can be used. I will keep you informed. I will do a blog of how we did it assuming the truck deal comes off. Quote Link to comment Share on other sites More sharing options...
johnhughes Posted November 28, 2014 Share Posted November 28, 2014 Cab over engine vehicles are warm, I run my unimog without door tops all year and only pit on the heater for five minutes to demist the windscreen! Quote Link to comment Share on other sites More sharing options...
winchman Posted November 28, 2014 Author Share Posted November 28, 2014 Cab over engine vehicles are warm, I run my unimog without door tops all year and only pit on the heater for five minutes to demist the windscreen! Thanks just never had a cab over before, once had a Land rover with no heater and that was grim. Quote Link to comment Share on other sites More sharing options...
winchman Posted December 1, 2014 Author Share Posted December 1, 2014 Why do some RLs have twin rears and some don't? Could I use a twin wheeler with single wheels at the back? How much are tyres? If I bought a twin wheeler with only singles at the back how hard is it to find two more wheels? Quote Link to comment Share on other sites More sharing options...
Richard Farrant Posted December 1, 2014 Share Posted December 1, 2014 Why do some RLs have twin rears and some don't? Could I use a twin wheeler with single wheels at the back? How much are tyres? If I bought a twin wheeler with only singles at the back how hard is it to find two more wheels? The recovery and tipper military RL's had twin rears, wheels are different and tyre sizes are 9.00-20 against 11.00-20 on the normal RL cargo versions with single rears. Quote Link to comment Share on other sites More sharing options...
winchman Posted December 1, 2014 Author Share Posted December 1, 2014 The recovery and tipper military RL's had twin rears, wheels are different and tyre sizes are 9.00-20 against 11.00-20 on the normal RL cargo versions with single rears. Thanks Richard. One I have looked at when you look from the rear the brake drums stick out past the single wheel fitted? The body is missing so I have no idea what it was, is this correct so should it have twin wheels? Quote Link to comment Share on other sites More sharing options...
winchman Posted December 1, 2014 Author Share Posted December 1, 2014 Just wondering if anyone local to me could show me around an RL or K9, then if I ever find one I would have some idea what to look for? Quote Link to comment Share on other sites More sharing options...
Richard Farrant Posted December 1, 2014 Share Posted December 1, 2014 Thanks Richard.One I have looked at when you look from the rear the brake drums stick out past the single wheel fitted? The body is missing so I have no idea what it was, is this correct so should it have twin wheels? Providing it is on 11.00-20 tyres, then that sounds correct, the rims are offset and reversed when fitted to the front. You do not use twins with the 11.00 tyres/wheels Quote Link to comment Share on other sites More sharing options...
winchman Posted December 1, 2014 Author Share Posted December 1, 2014 Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.