tim gray Posted May 8, 2012 Share Posted May 8, 2012 Hi guys,If i were to get some wheel nuts made what type of steel is best bet ? Regards Tim Quote Link to comment Share on other sites More sharing options...
ruxy Posted May 8, 2012 Share Posted May 8, 2012 BS. 970 En5. (30 carbon) P condition @ 35 tonf/in2 is sufficient --- or near equiv. such as 6A Quote Link to comment Share on other sites More sharing options...
tim gray Posted May 8, 2012 Author Share Posted May 8, 2012 BS. 970 En5. (30 carbon) P condition @ 35 tonf/in2 is sufficient --- or near equiv. such as 6A Cheers Ruxy, Can i have that in english please:D Sorry mate could not resist, got the first bit, but P condition 35....etc ? Regards Tim the dunce Quote Link to comment Share on other sites More sharing options...
ruxy Posted May 8, 2012 Share Posted May 8, 2012 (edited) You need something that is "free-cutting" for machining relatively easy without tearing. Not something too cooking such as Leadloy that is basically a En2 (low carbon). Such as En6 or 6A - the maximum carbon is 0.4% (into "Medium carbon steel range". En5 is supplied in normalized,or hardened & tempered (you need to avoid post heat-treatment). The property letter basically indicates the strength (derived from heat treatment). IIRC - starts at M , but lowest commercial is probably P going, Q. R. S. T. U. V. W. X. Y. Z Z = 100 tonf / in2 For a wheel lug nut that is deep - then P is more than adequate , the threads will be quite tough , the case will be tough to prevent spannering / socket marks , you don't want anything with hardness as there would be a danger of shear at the thread roots. I have been out of all of this a few years now, at the end of the day - you will have to see what is available in hex. stock bar to greatly reduce machining costs, a good steel stockist should have comparison tables as you could find the same stuff under other ref. Edited May 8, 2012 by ruxy speling Quote Link to comment Share on other sites More sharing options...
tim gray Posted May 9, 2012 Author Share Posted May 9, 2012 You need something that is "free-cutting" for machining relatively easy without tearing. Not something too cooking such as Leadloy that is basically a En2 (low carbon). Such as En6 or 6A - the maximum carbon is 0.4% (into "Medium carbon steel range". En5 is supplied in normalized,or hardened & tempered (you need to avoid post heat-treatment). The property letter basically indicates the strength (derived from heat treatment). IIRC - starts at M , but lowest commercial is probably P going, Q. R. S. T. U. V. W. X. Y. Z Z = 100 tonf / in2 For a wheel lug nut that is deep - then P is more than adequate , the threads will be quite tough , the case will be tough to prevent spannering / socket marks , you don't want anything with hardness as there would be a danger of shear at the thread roots. I have been out of all of this a few years now, at the end of the day - you will have to see what is available in hex. stock bar to greatly reduce machining costs, a good steel stockist should have comparison tables as you could find the same stuff under other ref. Cheers Ruxy, Good good write up and got it now. Appreciate the comments re Hex bar but unfortunatley the flats on the nuts are actually inside the curcumference of the seat and taper. Got some other bits being made up so i am yet to get a unit price, if it makes it better i may get a few extras made up. Cheers for the valued info. Tim Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.