question Ferret - Generator to Regulator Cable routing

[Diana and Jackie]

Just replaced our Ferret Generator - but the cable routing between the Generator and Regulator doesn't look right as it goes below the nearside rear propshaft.

 

The clips adjacent to the fuel filter are all missing which is about to be fixed.

 

Please can someone provide the correct routing of the cable?

 

D&J

[ferrettkitt]

Not the best picture but it shows the generator cable going through where the petrol pipe joins the union above the gearbox mounts. This was during the strip down so this would have been how 02CA35 ended its service life. It should also have a a p type clip under the inlet manifold to hold the cable up so that it doesn't catch on the prop shafts. No pic of that though I'm afraid

 

 

[ATTACH=CONFIG]73369[/ATTACH]

Edited March 1, 2013 by ferrettkitt
grammar

[ferrettkitt]

[ATTACH=CONFIG]73370[/ATTACH]

 

This is a closest I can get to the mounting on the manifold

[Diana and Jackie]

Thanks Andy,

 

I thought you might reply! Another bodge to sort out, I guessed it was all wrong and its also been rubbing against the fuel tank, which is why it needs a P clip under the manifold.

 

Grateful for confirmation of the routing.

 

Now the hard bit - doing it properly

 

D&J

 

 

 

 

[ATTACH=CONFIG]73370[/ATTACH]

 

This is a closest I can get to the mounting on the manifold

[ferrettkitt]

Happy to help