skapunkninja Posted February 19, 2011 Share Posted February 19, 2011 Hi guys. I'm trying to fit the handshake cable into my 43 mb, but can't figure out where it should sit to work correctly. It didn't have one to start with, and has no brackets fitted to hold it. Anyone got any pictures of how it should sit? Quote Link to comment Share on other sites More sharing options...
deadline Posted February 19, 2011 Share Posted February 19, 2011 (edited) Its in the SNL. Pg 168 and 176. There are two (early) or three (late) clamps. One on each end and later on they added one on the bell housing. Not sure when the bell housing clamp (the third one) was added, But late 42's did not have it. IIRC if you have an internal type brake, then you need the clamp on the bell housing. As for routing it goes under the transfer case, but over the cross member. You'll see the passage when you look for it. Edited February 19, 2011 by deadline Quote Link to comment Share on other sites More sharing options...
jeepfinger Posted February 23, 2011 Share Posted February 23, 2011 Hi ' I would recommend looking on Jeepdraw on the G503.com. There is a GPW of Al Brass that has tons of photos including handbrake cable routing. Dave Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.