Jump to content

Wanted - Jeep rear three quarter panel


Recommended Posts

I bit the bullet. Getting the correct measurement was hair-raising, as there is little to work on. In the end I did triangulations from the grab-handle bolt hole centres, but even then I had to bridge a fairly wide gap with the mig as a result of the compression/stretching on the damaged rear three quarter.

I guess I could have repaired the damaged bit, but I'm short of time. Very happy with this.




Test fit;


Thanks for the help and tips.


Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...