Chrisg

22 hours ago, AndyFowler said:

Still slow progress Mike , need to retire ASAP 🙂

Then you'll be far to busy to finish Daisy 

If you google 5/16x 20tpi the answer is a Uns thread . unified special 

I suspect that it's too late now but I can get the proper bearings £106.00 for the two including posting 

chris 

Sorry haven't got a price yet 

They should be available in U.K.  I can check prices & delivery tomorrow if you would like 

chris 

10 hours ago, Richard Farrant said:

 

i am not sure of the number off the top of my head, but think it also had a name, could have been Multibond. Apparantly it was used by truck manufacturers to bond body panels on cabs.

Possible multi bond 330 

G & s valves Godalming 

Back after 7 days. Thoroughly enjoyed it met up with old friends & made new ones 

Have a look the green barn photos on Facebook. Where we replaced the roof & part of the side panels 

4 hours ago, MatchFuzee said:

I wasn't very happy on day one with the new forum but I have found that with use my feelings towards it are improving.

If you give the new forum a go, hopefully as you become more familiar with the forum, it will become easier and therefore enjoyable to use.

 

I also wasn't too happy on day one but I find it's getting easier to navigate around the forum day by day 

Thanks to all involved  for all the hard work 

Lots of holes drilled. Nearly all in the right place

The last price I've got from Roy Elvis in 2005 was 165.00

We normally camp with the champ camp with two caravans which we cover up with a parachute is this acceptable this year or will we be banished to civilian camping?

Waltzing?

They are skf numbers and the first number for the reference is the letter I not a number As far as I can remember there was no Timken equivalent

chris

Richard, the inner is 1 1/2" x 3 3/8" x 7/8" x 0.209" equiv. SKF 1.131089/9 and the outer is 13/16" x 2 7/16" x 0.829" x 0.591" equiv. SKF 1.131122/3

 

Changing them is straightforward, they're Timken type so same procedure as with any Timken wheel bearing.

Might be unipren 12

My champ ignition barrel has the number 16 the key is fv16. One rear locker has fv18 the other has the number 4

the ignition key is original the two locker keys I had cut to fit the locks. The make on the keys is Silca & the key model is uni 2

Don't trap your fingers when refitting the half shaft. It hurts

Should be there

:tup:: Thanks Degsy fascinating read

I'm going. Not sure where I'm camping yet as they don't seem to want a caravan covered with a parachute where I would normally be

Should be in the normal spot

I'm going. Not sure where I'm camping yet as they don't seem to want a caravan covered with a parachute where I would normally be

:tup:: Much appreciated

Ok so logistic services non explosive storage business stream material park (vehicle)