justinb
-
Posts
129 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Blogs
Events
Articles
Store
Downloads
Posts posted by justinb
-
-
13 hours ago, Ronsandt said:
So how much life is left in them if off roading?
You don’t really need any rubber pads off road at all , as long as the bushes and pins are ok it’ll last ages off road .
-
-
Sent you a message
-
thanks for the info lads
-
evening folks,
does anyone know the RAL number for the white paint used on the cvrt cummins?
cheers
justin
-
4 minutes ago, mac_xpert said:
Out of interest do you have a petrol, diesel or both?
4 minutes ago, mac_xpert said:Out of interest do you have a petrol, diesel or both?
I had the k60 2 stroke diesel
-
I never had any problems starting mine ,hot or cold
justin
-
evening all ,
I have a serious hydraulic oil leak on the steering rack (mk 2 )
is it possible to change the seals on the right hand ram (looking from the top) with everthing in situ or should I remove the whole thing?
cheers
justin
-
i'd quite like to build a propane rarden for the sabre ,would these boards do the job and how complicated is the rest of the engineering?
justin
-
Yes chap , just off junction 25
-
On 8/12/2018 at 6:28 PM, Manylandrovers said:
Hi I’m after some j60 bits to finish my rebuild. Starter, flywheel and dipstick and tube and drain tap. Anyone got a scrap j60?
The dipstick and tube are there and the flywheel , pretty sure the drain tap is there as well
-
-
I have an old seized engine in the workshop , I’ll have a look tomorrow
- 1
-
looking good chap .
brings back some memories of the mess mine was in.
- 1
-
Ok , thanks for looking
regards
justin
-
That would be brilliant , thanks .
i know the stolly takes 14:00 x 20 tyres
cheers
justin
-
evening all .
I'm after a spare wheel for a mk 2 stolly if anyone has one ,tyre or no tyre .
cheers
justin
-
evening folks .
my cvrt has an annoying problem where in reverse and turning at the same time it tries to jump a tooth on the sprockets!
all the shims and spacers are as the emers and the sprockets are in good condition /track tension correct .
the only fault I know of Is a slightly lazy torsion bar .
any ideas?
regards, justin
-
that would be brilliant ,thanks
justin
-
does anyone have the part no for the small pin which threads through the brake lining to attach to the spring on the bracket ?
it effectively holds the brake lining off the drum when the handbrake isn't in use .
cheers
justin
-
its highly likely the injectors are generic so you may be able to get them rebuilt.
j
-
xmod used to stock a lot of 432 stuff but ive not looked for ages ,someone was selling packs on milweb.
have you tried the forum ?
cheers
justin
-
On 09/01/2018 at 10:56 PM, lowfat said:
is it possible to change the seals without removing the big nuts ?or would it be easier to just change the pinion unit complete as I already have some of each hand .
just discovered a leaking seal now I've put oil back in.
cheers
justin
-
Sent you a pm
Cvrt track
in HMVF Classifieds
Posted
The track is now sold