Jump to content
munga1

Munga restoration

Recommended Posts

 

but I don't have a spares list or workshop manual for the munga.

 

 

That`s bad. I can help with "Repair manua"l, best quality copy from German Club.

 

Interest? Please send a private E-Mail.

Share this post


Link to post
Share on other sites

hi

 

any suggestions out there. my two stroke engine wont run on idle, it only runs fast around 2000 rpm

the carb has been set up ok I think, I had stripped the carb twice to clean it, and set it up. according to the manual. there are no air leaks on the carb, and it starts first time but runs too fast

 

any suggestions

 

alex

Share this post


Link to post
Share on other sites

I suppose you have checked the obvious things like sticking throttle cable, butterfly actually closing fully? It must be getting excess air from somewhere, are there any vacuum tubes missing or something like that, and have you tried dribbling a little fuel on the manifold joints to see if the speed changes. Is the throttle spindle worn? I am not really familiar with the Munga, but those are the things that come to mind.

 

trevor

Share this post


Link to post
Share on other sites

hi

 

thanks for the answer. but I went out again and discovered that one of the butterfly valves was not closing correctly.

 

a little adjustment and it now seems to be running well, its a bit noisy tonight so I will run it more tomorrow.

thanks again

alex

Share this post


Link to post
Share on other sites

Excellent, I like an easy fix!

 

BTW - by noisy I take it you mean 'noiser than usual for a munga' ;)

 

trevor

Share this post


Link to post
Share on other sites

hi all

 

 

does anyone have a picture or drawing of how the cable fixes to the clutch lever, and what holds the clutch cable outer sheave .

I have looked at loads of You Tube videos and a workshop manual, but no where does it show the clutch cable set up.

if anyone has diagrams or drawings It would help me no end

 

regards

 

alex

Share this post


Link to post
Share on other sites

hi all

 

after checking what seems like every picture on the net I have the answer, all I need to do now is make the bracket that bolts onto the exhaust manifold

 

 

regards

alex

Share this post


Link to post
Share on other sites
hi all

 

 

does anyone have a picture or drawing of how the cable fixes to the clutch lever, and what holds the clutch cable outer sheave .

I have looked at loads of You Tube videos and a workshop manual, but no where does it show the clutch cable set up.

if anyone has diagrams or drawings It would help me no end

 

regards

 

alex

 

 

clutch.jpg

Share this post


Link to post
Share on other sites

hi

thanks for the answers about the clutch , but does any one know where to get a clutch pressure plate in the uk, second hand or new. I have part numbers

LUX 118-00009-20

SACHS 1882-140-002

its 180mm dia

 

thanks

 

alex

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×