Jump to content

justinb

Members
  • Content count

    111
  • Joined

  • Last visited

Community Reputation

10 Good

About justinb

  • Rank
    Sergeant

Personal Information

  • Location
    ilkeston

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. justinb

    cvrt road wheel shims

    evening folks . my cvrt has an annoying problem where in reverse and turning at the same time it tries to jump a tooth on the sprockets! all the shims and spacers are as the emers and the sprockets are in good condition /track tension correct . the only fault I know of Is a slightly lazy torsion bar . any ideas? regards, justin
  2. justinb

    stalwart handbrake

    that would be brilliant ,thanks justin
  3. justinb

    stalwart handbrake

    does anyone have the part no for the small pin which threads through the brake lining to attach to the spring on the bracket ? it effectively holds the brake lining off the drum when the handbrake isn't in use . cheers justin
  4. justinb

    FV432 Fuel tank and exhaust

    its highly likely the injectors are generic so you may be able to get them rebuilt. j
  5. justinb

    FV432 Fuel tank and exhaust

    xmod used to stock a lot of 432 stuff but ive not looked for ages ,someone was selling packs on milweb. have you tried the forum ? cheers justin
  6. justinb

    stalwart clutch

    is it possible to change the seals without removing the big nuts ?or would it be easier to just change the pinion unit complete as I already have some of each hand . just discovered a leaking seal now I've put oil back in. cheers justin
  7. justinb

    CVR(T) tillers

    Sent you a pm
  8. justinb

    CVR(T) tillers

    i'll have a rummage around . I may have the bits you need down at the unit
  9. justinb

    stalwart clutch

    three of mine are brand new already but i'll be checking the rest . justin
  10. justinb

    stalwart clutch

    that's exactly what i'd designed in my head ,have ordered some keyway steel and round bar . thanks again. justin yes not too bad at all ,I've ordered some new seals to go between the transfer box and the bevel boxes too
  11. justinb

    stalwart clutch

    thanks Richard . nothing like experienced knowledge over a manual. i'll have a word with Richard bannister and request that type. I don't have an old shaft so will have to make something up I think. ill look up the adjustment details re the intermediate plate . thanks again. regards justin
  12. justinb

    stalwart clutch

    hi bob . i'll probably get two new ones from Richard Bannister but will reline them if he doesn't have any. cheers justin
  13. justinb

    stalwart clutch

    While replacing the knackered transfer box on our mk2 stolly I decided to check on the clutch plates , both really need changing as there's not much meat .left on them . does anyone have any tips for aligning two clutch plates at the same time before refitting the gearbox /transfer box combo? it looks like the small tabs on the pressure plate had been left in well past the 1\2 wear stage ,is it worth refitting them ? kind regards justin
  14. justinb

    Wanted CVRT SABRE / CVRW Fox Parts

    I have made a mould for making grp night sight covers which apart from genuine hinges being hard to get looks spot on ,but theyre very time consuming to make hence not cheap. justin
  15. justinb

    Stalwart transfer box removal

    the sleeves on mine were seized and took a bit of violence to shift them ,getting the circlips back on is even more fun.
×