lowfat

Believe me I’ve know this particular anson from about 1980when it arrived at cosford. It’s got metal wings I even took the lady over and showed her. I guess it doesn’t really matter

The mk19 avro ansons data plate in the raf museum at cosford is described as “wooden wings”only early ansons had wood wings. I pointed it out in 2000 to the lady responsible for the error. It still says wooden wings

I just loaded Adblock on my computer and iPhone. All fixed now. But it was truly bad

It’s sh!te. 

Drove one of these

6 hours ago, Mark Ellis said:

I do, @radiomike7. And ? 

Ron is in Australia he has a thread ultimate forward control on Aus Land Rover forum. You have more chance of getting him there

Just loosen and rotate the back shell on the plug. It’s a usual occurrence to have to rotate the back shell 

At least its not just weighed in 

I call bullshit  its illegal to own a firearm without a certificate already. Has it stopped the criminal element? Its just more control for control sake

I use it on Helicopter electric systems it is authorised on Gas turbine engine electrical systems. It fixes lots of little electrical gremlins.

Super stuff

Stabillant 22 is what you need for your slip ring lubricant. About 40 quid for a tiny bottle. Every time you open an electrical connector put a dab of this on all the pins. It’s a contact enhancer. Last for years. 

http://www.helstongunsmiths.com/default.asp?ID1=426&ID2=0&ID3=0&ID4=0&CB=10%2F2%2F2020+6%3A43%3A09+PM

So long as the speeding tickets get answered and they get their fine Im pretty sure you could register it at Buckingham palace. 

have you seen this

https://www.the-saleroom.com/en-gb/auction-catalogues/gilbert-baitson/catalogue-id-ibgi10619/lot-d56ccc92-4588-4b6b-8760-ac0600cb37e2

That Cyprus johnny is always expensive..

Any links so that we can all be informed? otherwise its abit of a dead end....

15 minutes with a brush and some green irr paint would have it back to  full value ...

No rush Dale

It’s the foundry that cast the block. Sheffield 

Measurements would be great and I can knock one up

Liking it so far.. where did you get the B81 engine stand? I need one for one of my patients

I just had a delivery of ferrules 1/2 x 20 Tpi Female Brake Pipe Nuts (8104) For 8Mm Fuel/Brake Pipe .

guess I will have a busy afternoon.

Thanks for the pointers. I will try and touch base with him.

Meanwhile I made a prototype Pipe bender i used a 68 mm hole saw to copy the internal radius of the bend and scewd the blank to a piece of plywood.

I used 10mm bolt for the pivot point of the handle. I got some skate board bearing races of amazon for  the former. I got mixed results the test bend was perfect the full sized pipe ended up a little flat.

So small steps to get back on the stolly Mojo road.

I have to make a set of the front  caliper hard brake pipes. Ive got the 5/16 pipe . I would like to replace the female cones so I can have a bit of production run. Any body know the correct ones?

outstanding