terryb

You might want to try Bannister's for a gearbox. Terry

new old stock set of 6 £30 free postage and packing terry 0774 8990096

£170. can post, or collect from kent. Terry 07748990096

new old stock. track, £17.50 per link (in ten link sections) new road wheels, £120. rear idler wheels, sold in a vehicle set, steel type £180, rare original rubber type (4 wheels) £225, torsion bar £45. Clutch drum with lining kit £200, Scorpion gunners sight, £325, armoured cowl for same £150, Axle arm with hub £85, new oil filter housing £65, Scorpion crew heater assembly £65, new Scorpion OTIS rear turet bin (slant back) £265, new Scorpion turret side bin £125, Scorpion turret seat back £65, Driver's night vision periscope £325, front 'D' shackles £25. Rarden cleaning kit in bag £35. SA80 gun mounts-sold as a kit £25 located Kent. Pics on request. can ship Terry 0774 8990096

large brass hull drain plugs £14.95, voltage regulators £170 free shipping to uk addresses

please do!

Hi John, cvrt's always wanted one pump of the throttle to start from cold-never needed to pull out the cold start lever-just make sure it idles ok when up to temp. Original cvrt install had the oil bath air filter so mixture was probably set lean to allow for the pull through the filter. best wishes Terry

brand new and wrapped ferret wiper motors £29.95. Post 2.85. PM with details-will ship same day.Terry

charge bins for sale. please pm if interested. Terry

fire extinguisher, clean and unused, seal still in place £35

Correct Scorpion CVRT carb £55

complete 75mm inert armour piercing round in good condition with no damage £55

Roll of rubberised cork gasket, 1.5mm thick, 2' wide x over 3' long £15

been looking to purchase a T80U for some time now without success. Are there any available?

CVRT new unused track £15/link, boxed clutch drum £65, torsion bars, £49, road wheel axle and hub assemblies £55, Scorpion 76mm gunner's day sight £275, armoured mounting for same £125

set of smoke dischargers and mountings for T54/T55 tank £150

it seems there is a restriction between fuel in and the gallery that feeds to each delivery plunger. remove the spill return hose off the top of the pump and with the ignition on and electric pump running there should be some flow coming out of the spill return from the injection pump. Then take off the fuel delivery hose and blow through from spill to fuel in on the pump to see if there is a blockage. My 432 was plumbed incorrectly-the fuel delivery hose was connected to the spill return on the pump, and the spill return hose was connected to the fuel in on the injection pump-and it ran fine!!

sounds like no fuel delivery-if you take off the flexible fuel hose going into the top of the injection pump from the fuel filter above the engine hours counter ( there are two hoses going into the top of the pump- one is feed, one is spill return) make sure you have pressurised fuel being pumped out in quantity when you turn the ignition on

the rack is sticking-watch your video clip, and see how the rod struggles to move at the end of travel. It should move quickly all the way in until the far end of that adjusting screw is touching the steel contact pad visible on the ali pump body. This is basically the valve allowing fuel flow to the delivery plungers, and if its only partly open youre not getting enough fuel on cranking. Disconnect the solenoid to make sure it moves freely and easily by hand (if it does, then its the solenoid) known problem-speak to H on the 432 forum-he's had a few 'rack' problems don't adjust the screw until you can find the settings, its quite critical terry

thank you John

unfortunately they stole the certificates as well............

please see stolen section

stolen late last night from Manston, 3 off lee enfiled rifles with certs, .50 cal browning replica, steam cleaner, Karcher. I.R. blue compressor, yellow stick welder, huge amount of power tools, hand tools, tool boxes etcand my two clansman tank helmets-ANY LEADS GRATEFULLY ( AND CONFIDENTIALLY) WELCOME IF YOU HEAR OF ANYTHING FOR SALE

Thanks, have tried them-yet to receive a reply...........

looking for a turreted Saurer-anything considered, can collect-what have you?