Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 11/15/2018 in all areas

  1. 1 point
  2. 0 points
    Err, it's not water that they are selling guys ! David
  3. 0 points
    Probably drove it up mountains & charged premium £ to grockles
  4. 0 points
    Looks like the pukka wheel type to me
  5. 0 points
    Great to see your project under way. I will follow it with interest. Ian
  6. 0 points
    Shortly after these pictures were taken, the speaker and mount were removed to give the mount a couple of coats of varnish to seal the wood. It will be refitted later once it has had time to fully cure.
  7. 0 points
    I haven't finalised the mount and position in the Jeep yet. It needs to be removable to allow the dummy radio to tip open to access the storage below it and the rear Jeep locker. I think I'll make some wooden trays like in the Dodge, which will slot onto the Jeep side panel, but lift off again when needed. I'm very pleased with the look of the completed speaker.
  8. 0 points
    A small aluminium plate was cut for the data plate and a waterslide decal made with the data on. this was screwed in place with some tiny screws. The whole speaker was then given a sprayed satin clear coat.
×
×
  • Create New...