Jump to content
  • 0

Bedford 300 Oil Pressure Switch thread... thread.


Tamber

Question

With my usual good luck and amazing care(!), I've managed to break my oil pressure switch. (Connected the *switch* wire to the battery feed, rather than the other side of the light bulb. :embarrassed: What a moron.)

 

Now it's reading open constantly, which is not a good thing. I've pulled it out, and measured the thread, and would just like a little bit of a sanity check on my results.

 

My thread gauges say it's Whitworth, 18TPI 'G 5/16', and it's tapered... I did write down what I measured it as, but can't find that piece of paper any more. (It's probably still at work...)

 

Anybody know what thread it actually is; or -- in a less roundabout route -- where I could get a new oil pressure switch? (I'm going to try at the local parts place tomorrow, just in case they can find one.)

Link to comment
Share on other sites

2 answers to this question

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...