64EK26

Hi Sorry these have now gone Cheers Richard

Hi This was at Shrivenham some time ago (apologies for the bad photos) , Don't know much about tanks but I think it is a leopard tank. Cheers Richard

Hi Clive That make sense, it would be logical to be struck off census before being sold. The original cost of 13RE80 was £273 and 13 Shillings Cheers Richard

Hi 13RE80 was sold at Ruddington Auctions on 12th June 1961 43YR07 was sold at Ruddington Auctions on 10th November 1960 Hope this helps Cheers Richard

Hi I have a BSA 300w 24v Charger for sale (post war) , £150 collection from Fareham (nr. Portsmouth) I did have it running several years ago, but is sold as seen Message me if interested Cheers Richard

Hi Danny This is what the bearing looks like Length 1.18" (30mm) ID 0.905" (23mm) OD 1.383" (35mm) Cheers Richard

Hi Danny With the clamp bolt slacked off you should be able to rotate the steering cover sleeve without the main shaft turning. With the woodruff key removed you should be able to pull the steering cover sleeve off. I suspect that the top end of your shaft has become rusted and thus is a very tight fit so you could use a soft ended hammer and tap the main shaft whilst holding the outer sleeve (also apply some penetrating oil on the shaft which will also help). I would recommend that you extract and clean and grease the bearing. The outer sleeve is designed to move up and down a bit so that the steering wheel can be snugly fitted. The alternative is that you pull off the rubber yoke (Item 94) which is clamped to the inside of the bulkhead, on mine it was split to aid easy removal (looking at your photo, I think yours is also split), the old gaiter can then be removed, as the diameter of the steering wheel end is greater than the main column use some washing on the new gaiter so the it can be eased over the steering wheel end. Hope this all make sense, next week end when I get access to my spare steering box I will send you some additional photos. Cheers Richard

Hi Been searching through my in-service photos, the best I can come up with is this Jerry can holder ? Also just noticed, the dexion racking is quite different Cheers Richard

Hi - Not to hand, will post one later in the week, but this is the type I have (never seen one with legs on before) https://www.ebay.co.uk/itm/195905929538 Cheers Richard

Hi - don't know if it was fitted when in service (spent all its service life in Northern Ireland), when I restored it, there were 'witness marks' to show that a bracket had been fitted there at some point. The jerry can holder mounting holes align perfectly with the holes in the 'rear bulkhead' so that is why I fitted one. Cheers Richard

Hi I have one of these in my Rover8... Also can't find the part number in any of mine either, but the clamping bracket that holds the Jerry can in place does have a part number 333464 see https://www.seriesparts.co.uk/PartDetail?stockid=287 I use it for water as I have a slight leak in my radiator Cheers Richard

Thanks It will make a good doorstop Cheers Richard

Hi This has been lurking in my shed for some time... A dummy mine (has been filled with concrete to give a more realistic weight) about 14" in diameter What type is it? and is it saleable ? Thanks in advance Richard

Hi Having a clear out... I am told that these came off a running engine, but I didn't see it run... Engine Block with crankshaft, pistons and con rods (partially dismantled) £100 Cylinder Head £75 Inlet and Exhaust Manifold £75 or all the above plus some other bits (dynamo, water pump etc) £175 Will add some additional photos later in the week Collection Only from nr. Portsmouth, message me if interested Cheers Richard

Hi What size are you after ? Cheers Richard