Jump to content

42 chevy

Members
  • Posts

    517
  • Joined

  • Last visited

Reputation

10 Good

About 42 chevy

  • Birthday 04/04/1963

Personal Information

  • Location
    Kent Island, Maryland, East coast of the U.S.
  • Occupation
    Retired T/Sgt United Sattes Park Police

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Looking gor a repair manual for Quad C8 tractor. Regards John G
  2. Long shot. Looking for wheel studs and lug nuts for a 6 pounder. Need 3 of each. John G
  3. your toe in on the front axle should be closer to 1/8" +/- 1/16"
  4. All' We are in need of starter motor for a Morris Quad, the amerature in ours in bent. Any leads appreciated regards John G
  5. All; Looking for a starter for a Dingo. regards John G
  6. Looking for 4 complete rubber track pads for a Stuart tank. Only interested in usable pads. regards John G
  7. All. Need help in locating new piston cups/brake diaphragms for a matador with air brakes. regrads John G
  8. I was ingormed that Rex Ward sold off the business, if this true, can someone advise who bought the business. Regards John G
  9. Great job there lads, I am glad you made the wise decision not make the earlier run and worked out the engine problem, she sounds good. John G
  10. 2 thoughts, you could be sucking air because of a bad fitting or cracked line. Also, check your coil and condenser. Both after mentioned items can be affected by heat if they are old. John G
  11. I logged in this morning and to my amazement, 1,000,018 views !!!!!! Now if that doesn't give you final push to make it to Brighton. CARRY ON....... John G
  12. during dinner this evening, I will raise a glass and toast your gang! John G
  13. I have been following both of your build threads for years on this forum. I remember when you got excited when you view count on the Dennis build reached 500,000. With that said, your are FAST approaching 1,000,000 views on the Thornycraft build thread. Always fascinated with the molds you fabricate and the solutions you come up with trying to replicate original parts. I have no doubt you will be ready for Brighton! John G
  14. Steve, On our big trucks, Ward LaFrance Diamond T etc, we use a welting that is 1 1/2 to 2 inches wide depending on the width of the strap and 1/16 inch thick, sometimes 1/8 inch. regards John
×
×
  • Create New...